Simrad SP270 Manual de Instalação descarregar pdf (Página 67)

Installation procedures

851-160572 / B

The connection of the speed log (1) and the course gyro (2) will

be described in chapter Connecting auxiliary equipment.

Transceiver Unit cabling

The cable numbers on figure 14 and in the following

procedures refer to the numbers on the cable plan and the

interconnection diagram.

1 All cable connections to the Transceiver Unit must have a

slack to allow the Transceiver Unit to move up to 10 cm

because of the flexible shock mounting.

2 Start the termination with cable no.6. This because this

cable is connected to the lowest row of the terminals on

E201. Use the surplus of cable no.4, or a similar type of

cable. Use the cable gland on the left hand side (refer to

figure 15) and terminate the main screen of the cable as

shown in figure 16. For termination of each cable pair

with screen, refer to the interconnection diagram. Use a

part of the enclosed cable sleeve on the screen of each

cable pair.

(CD3416)

6 4 5

L N

GND

Figure 15 The cable

connections in the bottom of

the Transceiver Unit

3 Continue with cable no. 4 through the cable gland on the

right hand side (see figure 15) and make the termination of

the main screen according to figure 16. Make the

connections to terminal E201 according to the

interconnection diagram.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 253 254

Sem comentários

Simrad SP270 Manual de Instalação Página 67