Simrad SP270 Manual de Instalação descarregar pdf (Página 109)

Start-up procedures

160573/A

Checking; th,

, ,

ar room

functions

Note that this checklist has to be coordinated with chapter 4.

Check that the depth is sufficient for lowering of the

transducer.

Start up the Sonar Control Unit and

check that the green

ON/OFF-HOIST button lights and that the upper line in

the menu shows the text TRANSD. POS: UPPER.

Set the motor overload switch S301 in the motor control

unit to normal

position by pressing the black button

marked I"

Set the hoistingllowering switch in the motor control unit

to REMOTE position.

Select the Hull Unit to MIDDLE position by a short press

on the LOWER button

, and check if the

text LOWERING:

MIDDLE is shown

in the

menu. Check that both

the

HOIST and LOWER buttons light

during the lowering,

and that both extinguish when the transducer stops in

the middle position. The menu should now show the text

TRANSD. POS: MIDDLE.

Press the LOWER button, and

check if the text

LOWERING: LOWER is shown in the menu. Also check

that both buttons light during the lowering, and

that only

the LOWER button lights when the transducer stops in

the fully lowered position. The menu should now show

the text TRANSD.

POS: LOWER.

Select the

MIDDLE position by a

short press on the

HOIST button, and check if the text HOISTING:

MIDDLE is shown

in the menu. Check that both the

HOIST and LOWER buttons light

during the hoisting,

and that both extinguish when the transducer stops in

the middle position. The menu should now show the text

TRANSD. POS: MIDDLE.

Press the HOIST button

, and check if the

text

HOISTING: UPPER is shown in the menu. Also check

that both buttons light during the hoisting, and that only

the HOIST button lights when the transducer stops in the

fully hoisted position. The menu should now show the

text TRANSD. POS: UPPER.

Press the LOWER

button for approximately 2 seconds

and check if the text

LOWERING: LOWER is shown in

the menu. Also check that both buttons light during the

lowering, and that only the LOWER button lights when

the transducer stops in the

fully lowered position. The

menu should now show the text TRANSD. POS: LOWER.

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 253 254

Comentários a estes Manuais

Sem comentários

Simrad SP270 Manual de Instalação Página 109

Comentários a estes Manuais

Manuais e produtos relacionados com não Simrad SP270