Simrad SP270 Manual de Instalação descarregar pdf (Página 29)

Introduction

851-160571 / B

Mechanical units

Mechanical units may be heavy. Using a suitably certified lifting

apparatus, lift the unit out of the crate and place it in a stable

position on the floor/work bench.

Inspect the unit for damage and remove any packing material

that may be inside the unit.

Transducers

Transducers may be supplied mounted to a hull unit (if any), or

packed separately. Crates are normally identified by the order

number and the serial number.

The transducer face must be protected by a rigid, padded cover

(e.g. a wooden box lined with foam rubber) all the time it is

exposed to the risk of physical damage.

Note Once the units are unpacked, great care must be taken to ensure

that transducers and cabling are not exposed to any mechanical

stress.

Re-packing

If the unit is not to be installed immediately, re-pack it in its

original packing material to prevent damage in the intervening

period.

→ Refer to the information on page 18.

Storage

Pre-installation storage

The equipment should be stored in its original transportation

crate until ready for installation. The crate must not be used for

any purpose for which it was not intended (eg. work platform

etc.).

Once unpacked, the equipment must be kept in a dry, non

condensing atmosphere, free from corrosive agents and isolated

from sources of vibration.

Note Do not break the seal to open a circuit board package before the

board is to be used. If the board package is returned to the

manufacturers with the seal broken, the contents will be

assumed to have been used and the customer will be billed

accordingly.

The unit must be installed in its intended operating position as

soon as possible after unpacking.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 253 254

Sem comentários

Simrad SP270 Manual de Instalação Página 29