
clicks into locked position. F The EQ32 MKII must be turned off while
connecting/disconnecting the transducer cable.
.-%!INTERFACECONNECTIONS - NMEA 0183 interface con-
nections are made to the receptacle marked ’NMEA’ on the rear of the
cabinet - turn the plug’s coupling ring clockwise until it stops.
F The EQ32 MKII must be turned off while connecting/disconnecting
the interface cable.
The installation should be carefully planned in advance, keeping in mind
the standard cable length of 10 meters (32feet) which is connected to the
transducer. In the event where the standard cable is not long enough, up
to an additional 10 meters (32 feet) may be connected without affecting
the performance of the system. The cable must be of the same type as the
standard cable. F The EQ32 MKII must be turned off while connecting/
disconnecting the transducer cable.
The use of longer cable runs, while possible, always increases the likeli-
hood of increased interference and decreased performance. Care must be
taken when increasing the cable lengths to ensure that proper, adequate
and consistent shielding is maintained, that cable of adequate cross sec-
tion is used, and that all connections are properly made and protected
from the effects of the marine environment.
If possible, running the transducer cable through a grounded conduit will
greatly decrease the likelihood of interference. Likewise, the EQ32 MKII
transducer cable should be run as far as possible from other electrical ca-
bling. If it is absolutely necessary to pass close to other cabling, it is best
to keep as much distance as possible, and to make all crossings as close
to a right angle as possible.
The EQ32 MKII’s transmitter is designed to match the transducers de-
scribed in section 5.4.1 on next page.
"ASICCABLEANDTRANSDUCERINFORMATION
%1-+)))NSTALLATIONANDSERVICE #HAPTER
41
Comentários a estes Manuais