Simrad EQ 55 Especificações descarregar pdf (Página 38)

/PTIONALCONNECTIONS

)3$ATALINE$ATABOX

EQ32 MKII NMEA Data Box

0IN

1White TX A (DATA OUT) + Radio nav input

2Brown TX B (RETURN) -

3YellowRX A (DATA IN) WHT NMEA bus to

4 Green RX B (RETURN) GRN repeaters

%XTERNALPOSITIONHEADINGANDSPEED

EQ32 MKII NMEA

0IN

3YellowRX A (DATA IN) NMEA0183

4 Green RX B (RETURN)

0OWERSUPPLYCONNECTIONS - The internal voltage regulator will al-

low the EQ32 MKII to operate normally over the power supply voltage

range from 10 to 32 Vdc. Connections between the EQ32 MKII and the

external power supply are accomplished by means of the supplied power

cable, which is approximately 1.5 meters long.

After connecting the cable to the power source, push the plug as far as it

will go into the two pin receptacle marked ’PWR’ on the rear of the cabi-

net and turn the plug’s coupling ring clockwise until it clicks into locked

position.

&USE - Warning! Using a fuse which is not specified for your equip-

ment can cause it to blow the instant the EQ32 MKII has been switched

on or it will not protect the equipment in the event of trouble.

4RANSDUCERCONNECTION - A 10 meter cable is supplied for connec-

tion between the transducer and the display cabinet - EQ32 MKII. Push

the female plug, as far as it goes, into the receptacle marked ’ECHO’ on

the rear of the cabinet and turn the plug’s coupling ring clockwise until it

#HAPTER %1-+)))NSTALLATIONANDSERVICE

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 59 60

Sem comentários

Simrad EQ 55 Especificações Página 38