Simrad TP22 Manual de Instruções descarregar pdf (Página 20)

Tillerpilots TP10/TP22/TP32

E04818 Issue 1.0

Wire Color

Brown +12V DC

Blue 0V

• Use a suitable gauge cable for the run from the socket to the sup-

ply (see Fig 5.6 on previous page).

• Connect to the vessel’s switch panel via a 10 Amp fuse or breaker.

• Do not fit other electronic or electrical equipment to this cable, or

“tap into” the supply from a nearby cable – always wire each piece

of equipment to its own breaker in the electrical panel.

• Ensure all connections are well made. Poor contact will result in

loss of thrust from the Tillerpilot and slower speed of response.

• If in any doubt, employ a qualified engineer to install the equip-

ment.

5.3 Interfacing via SimNet

The TP22 and TP32 Tillerpilots are linked to other SimNet-

compatible equipment via the integral SimNet cable and plug in

the bulkhead socket.

All SimNet units (Instruments, Chartplotters, Radars, Auto-

pilots, etc.) use the same single cable to share data on the high

speed network. If there are no spare SimNet ports convenient, a

three-way cable joiner can be used to create an additional port

(see Fig 5.8, p. 21).

STBY

TAC

STB

UTO

Brown

12V DC

Blue

Fig 5.7 - TP10 wiring

5.2.2 Installing the TP10

The TP10 Tillerpilot operates from a 12 V DC supply and is

connected to the supply by two wires (Fig 5.7). Although the

cable is supplied with bare ends, it is recommended that a good

quality waterproof plug and socket is fitted for maximum relia-

bility. A suitable plug and socket set is availble as an optional

accessory (part no. SKT100; see section 6.4).

Wire to the electrical supply as follows:

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Sem comentários

Simrad TP22 Manual de Instruções Página 20